Start-up is effected simply and easily in Basic Mode by assigning the sensors to actuators using a screwdriver. All radio components with the exception of the Home Manager, Room Manager, communication interface and temperature input can be assigned in this way.

And this is how easy it is!

The RF SYSTEM BASIC MODE CARD, included with every component, shows the easy steps in clear and simple pictures. Note that the instructions may vary for different components.

Assignment sensor - actuator The actuator is installed and voltage is supplied. Briefly press the programming push-button on the actuator marked with ON/OFF Prog. and screwdriver symbol). The actuator switches the connected device (lamp, motor ...) and the LED on. Briefly press the desired push-button on the sensor (pushbutton, remote control ...). The actuator acknowledges the assignment by 2x flashing of the connected device and the LED. It is possible to successively assign several sensors (up to 15) to one actuator. It is also possible to start programming mode simultaneously on several actuators and assign one sensor or several to all. Quit programming mode by pressing the programming push-button on the actuator again. The LED and the connected device are switched off.

Deleting individual assignments Briefly press the programming push-button on the actuator The actuator switches the connected device and the LED on. Hold down the desired key on the sensor to be deleted for longer than 5 seconds. The actuator confirms the deletion by flashing the connected device and the LED five times. It is also possible to delete several sensors in succession in this way. Quit programming mode by pressing the programming push-button on the actuator again. The LED and the connected device are switched off.